Rabbit and Bloom flower printed


Susy and I were at the barn yesterday to print the bloom flower and bunny to the base of the new trays. [caption id="attachment_180" align="aligncenter" width="625"]screen printing Bloom flower print[/caption] [caption id="attachment_168" align="aligncenter" width="625"]Silk screen A closeup of the bloom screen before printing[/caption] Setup for printing the bunny.  The screen was a little small for the purpose because the squeegee only just fit across the screen.  Also because it's a small screen it's not possible to lift the screen very high as the ink then flows rapidly down the screen. Ideally, the screen would allow the squeegee to go the other way. For now it had to do. [caption id="attachment_185" align="aligncenter" width="625"]Red bunny printing In process of printing. Notice the tape used as a wedge because if the screen was lifted much higher the ink would end up at the bottom of the screen.[/caption] Red bunny screen printedTray base with a red bunny and the flower. Ready for construction.

Leave a comment


Please note, comments must be approved before they are published