Tray Stand Mark II

February 26, 2014

So my first tray stand required a rotating hinge. This not only added another component to the construction, but also made the stand somewhat flexible.  In addition, the rotating hinge wasn't particularly robust - having some play in the joint.  Checking out laser cut ply inspired a different design below.   [caption id="attachment_255" align="aligncenter" width="625"]tray stand Tray stand version II.[/caption] I don't have a picture of version II.  In part it was sooo cold at the barn that the glue emulsified!  Add to that, the single leg joint was stressed and under pressure broke. Back to the drawing board for version III.

Leave a comment

Comments will be approved before showing up.

Also in A Design Sensibility

Jaipur India

February 15, 2017

Continue Reading

Information and sign-in box

November 29, 2014

Continue Reading

Chicken Coup

July 06, 2014

Continue Reading

Hello!  Sign-up here for new products and offers.