Tray stand version IV

March 06, 2014

[caption id="attachment_235" align="aligncenter" width="625"]Tray stand version IV Tray stand version IV[/caption] This was a design improvement we liked so it was time to make another prototype. Now we were getting somewhere! Next was the material usage which was a bit high, i.e., the width of the ply could be skinned down to save in weight height and material usage. Only when version II (see design) was finish was it clear that there were mechanical and structural weaknesses on one side.  This was solved by adding an additional cross brace in version IV. [caption id="attachment_259" align="aligncenter" width="625"]Tray stand version IV Tray stand version IV[/caption] Version IV was tall approximately 33".  Thinking a little about how portable the tray stand might be, could it fit inside the tray? See version V.  


Leave a comment

Comments will be approved before showing up.


Also in A Design Sensibility

Information and sign-in box

November 29, 2014

Continue Reading

Chicken Coup

July 06, 2014

Continue Reading

Gallery table

July 01, 2014

Continue Reading

Hello!  Sign-up here for new products and offers.